Disco 240 Dmx Controller Manual -

You cannot connect this directly to a computer via USB (it has no USB port). However, you can connect a DMX recording interface (like an ENTTEC Open DMX) to the 3-pin output and capture your fader moves in software like QLC+.

Located on the far left, these buttons select which lighting fixtures you are currently controlling. Each button assigns a block of 16 DMX channels to the faders. Channel Faders (1–8) and Page Select Button The center of the console features 8 physical faders. disco 240 dmx controller manual

Note: Consult your fixture's manual to set its DIP switches according to these decimal addresses. You cannot connect this directly to a computer

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Each button assigns a block of 16 DMX channels to the faders

Chases are sequences of scenes played back-to-back to create motion and dynamic light shows. You can program up to 6 independent chases. Control Sliders (Speed & Fade Time)

: Only use cables specifically rated for DMX signal (110–120 ohm) rather than standard microphone cables to ensure reliability in high-stakes environments.

The controller features 30 banks. With 8 scenes per bank, you can program a total of 240 unique scenes (hence the name Disco 240). Chase Buttons (1 to 6)