Remove all foam, security tape, and zip ties securing the X, Y, and Z axes. Physical Assembly:
Apply a thin layer of lithium grease to the metal linear rails and the Z-axis lead screw every 50 hours of printing.
This guide is intended as a comprehensive reference, but always consult the official documentation provided by Qidi Tech on the included USB flash drive or via their official support channels for the most accurate and up-to-date information. qidi x-pro manual
Watch the nozzle; once filament extrudes smoothly in a straight line, tap . Unloading Filament
| © QIDI Technology
: If using both nozzles, ensure they are perfectly level with each other to prevent the "inactive" nozzle from dragging on the print.
If you need the actual PDF file for the diagrams, QIDI hosts their manuals on their official Google Drive or website. Remove all foam, security tape, and zip ties
Insert the plastic filament guide tubes into the feed holes at the top of the extruder and snap the other ends into the clips near the spools. 4. Bed Leveling Guide (Crucial Step)
Re-level the bed; clean the plate with IPA; use a glue stick. Clogged nozzle or printing temperature too low. Watch the nozzle; once filament extrudes smoothly in
| Material | Nozzle Temp (Manual) | Actual Best Temp | Bed Temp | Enclosure | | :--- | :--- | :--- | :--- | :--- | | | 190-210°C | 205°C | 50°C | Door Open | | ABS | 230-240°C | 245°C | 100°C | Door Closed | | PETG | 220-235°C | 230°C | 70°C | Door Half Open | | Nylon | 250-260°C | 255°C | 100°C | Door Closed + Vent |
You can also upgrade your X-Pro for advanced control:
